Can you run both pfSense pfBlockerNG and Pihole together? Yes, you can.

sh.

sudo wg show. .

Be sure to select wg0 as your interface when running through the pihole installer, and use the previous values for your IP and gateway.

I've also disabled Pihole to make sure that's not an issue.

Configure WireGuard VPN Clients and Connect to pfSense. I'm unsure about what to do, change. I'm unsure about what to do, change.

May 11, 2023 · The pfSense Plus software interface attached to the modem must be set to operate in promiscuous mode.

Apr 22, 2019 · Copy the client’s configuration file to your home computer, import it to your Wireguard app and click connect. Mar 25, 2021 · What i have: Linux server with installed wireguard, unbound dns, pihole, seafile. r/pihole.

sudo wg show. .

.

I.

Has anyone seen this behavior before ? The requests were "normal", not hitting a specific service or server. May 11, 2023 · The pfSense Plus software interface attached to the modem must be set to operate in promiscuous mode.

. .

The devices were totally random (IoT, PC's, Phones, TV's, etc).
com.
Enable Use Conditional Forwarding.

I'd rather not have to have two servers just to get this working.

net loads in 2 minutes and always formats badly.

I have an unraid server setup (6. . g.

0. WireGuard Overview¶ WireGuard is a new VPN Layer 3 protocol designed for speed and simplicity. r/pihole. 0/0, ::/0. 1.

With WireGuard tunnel working, SpeedTest.

. 0.

I'm currently running two Pi4s: one that has Pihole/Unbound/Wireguard (and that IP replaced my router's Primary DNS), and another than only has Pihole/Unbound (Secondary DNS).

.

The firewall must send all IPv6 DHCP requests with a defined and expected DUID.

To check the status type.

Comparing to other solutions, such as OpenVPN or IPsec, it aims to be faster, simpler, and leaner while avoiding the massive overhead involved with other VPN solutions.